MSc Computational Chemistry ยท Electronic Structure
DFT Geometry Optimization Workflow
Follow a DFT optimization from starting structure through convergence, frequency validation, and final electronic interpretation.
Theory
DFT geometry optimization searches for a stationary point on the potential energy surface. Gradients, energy changes, and frequency calculations validate the result.
Procedure
- Choose functional and basis set.
- Optimize geometry to force convergence.
- Run vibrational frequency analysis.
- Inspect charges, orbitals, and thermochemistry.
Observations
- Initial geometry: The starting structure has long bonds and high gradient norm. Initial forces exceed the convergence threshold. The geometry requires optimization before property analysis.
- SCF convergence: Electronic energy converges within the requested tolerance. Density matrix change falls below the SCF threshold. The wavefunction is stable enough for geometry steps.
- Optimized minimum: Frequency calculation reports no imaginary modes. Positive Hessian eigenvalues support a local minimum. The optimized structure is valid for reporting properties.
- Transition-state warning: One imaginary frequency follows the reaction coordinate. A negative Hessian eigenvalue indicates a saddle point. Use TS validation or reoptimize if a minimum was intended.
Interpretation rule
A geometry is a true minimum only when the optimization converges and all harmonic frequencies are real.
Validation
Method sensitivity should be checked for systems where dispersion, spin state, or charge transfer matters.
This page runs an interactive simulation of the experiment; enable JavaScript to use it.